One symptom, many possible causes. That is the central challenge of HVAC repair, and it matters even more in Glendale, AZ, where failures seem to wait for the most extreme weather of the year. Equipment that will not start at all might have a failed low-voltage transformer, a thermostat that has stopped calling, a control board that has lost its sequence, or a float switch shut off by a backed-up condensate drain. Equipment that runs but falls behind is a different list: a weak capacitor, a worn contactor, a low charge, a dirty flame sensor, or a filter clogged badly enough to starve the blower.
Most of our service calls are for AC Repair and Furnace Repair. If something has stopped working, start there.
Warning Signs for HVAC Repair
The sooner you notice these red flags, the easier and cheaper the fix. Here are the most common indicators that it's time to call a professional:
- Short cycling, where the system starts and stops without ever reaching the setpoint
- Airflow at the registers that feels weak in every room
- Unfamiliar sounds from the equipment, like squealing, grinding, or banging
- A humming outdoor unit that never kicks on
- Puddles near the furnace or air handler from a blocked drain line
- A breaker that trips whenever the system tries to run
- Higher energy bills with no improvement in comfort
- Vents blowing warm when you want cool, or cool when you want heat
Act Before It Gets Worse
What seems like a minor issue today can take out a compressor or heat exchanger tomorrow. Don't wait, call (602) 835-7335 and we'll take a look right away.
